AEM SM100 - Checking and Adding Engine Coolant

Maintenance
Checking and Adding Engine Coolant 7.7
75
[en-US] | 08/2022 | 5100064108 | SM100 | Operator’s Manual
7.7 Checking and Adding Engine Coolant
WARNING
Burn hazard
Engine coolant is hot and under pressure at operating temperature. It can
cause severe personal injury.
► Check the engine coolant level only after the engine has been shut
down and is cool.
► Do not add engine coolant directly to the radiator when hot.
► If you must drain the engine coolant while it is still hot, stay clear of the
hot engine coolant to avoid being burned.
► Check the coolant level at the reserve tank and add coolant as needed.
► Wear eye protection when handling the engine coolant.
► Tighten the radiator cap securely after checking the radiator. Steam can
escape during engine operation if the cap is loose.
WARNING
Burn hazard
Engine coolant can contain alkali.
► Avoid engine coolant contact with skin and eyes.
When
Every 10 hours or daily
Requirements
• Machine parked on a level surface
• Machine shut down and cool to the touch
• If needed, an equal mix (50/50) of distilled water and ethylene glycol or-
ganic acid technology (OAT) long life coolant concentrate
Overview
The engine coolant recovery reserve tank is located on the ride side of the
engine compartment.
1
2
Fig.57: Coolant bottle and fill cap
Procedure
1. Check that the engine coolant level is between the min and max
lines(1).
7