Operation
6.8 Operating the Machine in Extreme Weather Temperatures
42
Operator’s Manual | SM100 | 5100064108 | 08/2022 | [en-US]
Stopping the engine
453kg
(1000LB)
SM 100
ISO 14397
1000463295
Fig.12: Position 0
1. Unfasten the seat belt in order to avoid unintentional operation.
2. Allow the engine to cool down at low idle for 5minutes without any
load.
3. Turn the key to position0.
4. Remove the key before leaving the operator platform.
Note: If it is necessary to disconnect the battery after stopping the engine,
wait 2minutes in order to avoid damage to the control electronics.
6.8 Operating the Machine in Extreme Weather Temperatures
WARNING
Accident hazard
Cold hydraulic oil can lead to unpredictable machine movement and a possi-
ble loss of machine control.
► Operate the machine with extreme care.
WARNING
Explosion hazard
Evaporative starting fluids can cause unexpected explosions.
► Do not use evaporative starting fluids, such as ether, on this engine.
NOTICE
Operating the machine without warming it up first can render the machine in-
effective and equipment damage can occur.
► Warm up the machine according to the information below.
Do not use the machine in ambient temperatures above 45°C (113°F) or be-
low -20°C (-4°F).
Carefully observe the recommendations in the following sections when oper-
ating the machine in extreme temperatures.
Cold temperatures
Cold temperatures affect the engine’s starting capability, and the hydraulic
systems will be sluggish until the system temperatures increase to the nor-
mal operating range. The following are actions that help minimize cold start
effects.
Engine/electrical
To Next Page
Loading...
Need help?
General