Operation
Using the Manual Coupler 6.20
57
[en-US] | 08/2022 | 5100064108 | SM100 | Operator’s Manual
• The machine can suddenly tip, sink, or fall when moved onto surfaces
that have newly filled earth.
• Drive slowly when operating on rough terrain.
Operating over curbs
• The machine tips quickly forward or backward as it travels over a curb.
Keep feet and body inside the operator’s station and away from the
tracks at all times.
• Do not drive the machine in reverse over a curb with no load or the lift
arm raised.
• If repeatedly driving over a curb is necessary, build a dirt ramp to make
the ascent more gradual.
6.20 Using the Manual Coupler
A coupler is a device for mounting and removing attachments without the aid
of tools.
WARNING
Crushing hazard
► Keep others clear of the area while mounting or removing attachments.
► Keep hands clear of the area while mounting or removing attachments.
► After the attachment has been mounted, check the coupler lower pin en-
gagement to make sure the attachment is secured. This will prevent the
attachment from falling off during machine operation.
► Set the attachment on level ground when removing it to ensure stability.
Notes
• Use only attachments that are approved by Wacker Neuson.
• Read and understand the instructions for use and operation of any at-
tachment used on this machine.
• Make sure the mounting pad on the attachment is clear of any debris to
allow to proper mounting of the attachment.
Fig.34: Lock levers
Mounting an attachment
1. Set the lock levers(1) to the unlocked (up) position.
Note: The attachment should be in a stable position on level ground.
2. Stand on the operator platform and engage the operator presence
pedal.
3. Start the engine and disengage the parking brake.
4. Tilt the coupler forward.
5. Ensure the lift arm is completely lowered.
6
To Next Page
Loading...