Maintenance
7.23 Replacing the Fuel Filter
94
Operator’s Manual | SM100 | 5100064108 | 08/2022 | [en-US]
5. If the track still does not have enough tension after applying grease
again, do not put the machine into operation. Contact a Wacker Neu-
son dealer.
6. Lower the machine to the ground.
7. Install the cover.
7.23 Replacing the Fuel Filter
WARNING
Explosion and fire hazard when handling fuel!
Can cause serious burns or death.
► Bleed the fuel system only if the engine is cold.
► Wear protective equipment.
► Never perform work on the fuel system near open flames or sparks.
► Do not smoke.
► Keep the maintenance area clean.
Environment
Use a suitable container to collect, store, and dispose of drained fluids and
lubricants in accordance with current environmental protection regulations.
When
Every 500 hours
Requirements
• Replacement genuine YANMAR fuel filter
• Container of sufficient volume to collect drained fluid
Procedure
1. Raise the lift arm and install the lift arm support device. For more infor-
mation, see Lift Arm Support Device on page 65.
2. Shut down the machine.
3. Allow the machine to cool for at least 5 minutes.
4. Lift the hood.
5. Interrupt the fuel supply by turning the fuel valve (1) 180° to the
CLOSED (up) position on the water separator (2).
To Next Page
Loading...
Need help?
General