Operation
6.2 Inspecting the Work Area
36
Operator’s Manual | SM100 | 5100064108 | 08/2022 | [en-US]
Avoid risk of injury or death
Before operating the machine, instruct all personnel in the area to stay away
from the machine while it is being operated.
While operating the machine, remain aware of people moving in the work
area. Be ready to react to these movements if necessary.
Lock the lift arm before servicing the machine. For further information, see
Lift Arm Support Device on page 65.
Do not allow someone to approach the machine while the machine is run-
ning or with the lift arm raised.
Starting and stopping
• Perform starting and stopping procedures according to this operator's
manual.
• Observe all indicator lights.
• Do not use starting fluid (for example, ether). Failure to comply can result
in an explosion, which can cause serious injury or death.
• Ensure that the machine is parked on level ground when stopping.
• Set the parking brake to avoid unintentional operation.
• Lower the attachments to the ground before exiting the machine.
After use
• Turn the engine off when the machine is not being operated.
• Ensure that the machine is parked on level ground when not being oper-
ated.
• Store the machine properly when it is not being used. The machine
should be stored in a clean location out of the reach of children.
6.2 Inspecting the Work Area
Before operating this machine, inspect the work area for unsafe conditions.
Be aware of any sharp drop-offs or rough terrain.
Remove objects or other construction material that could damage the ma-
chine or cause personal injury.
Always check for the following ground conditions before operating the ma-
chine:
• Inspect for signs of instability such as cracks or settlement.
• Be aware of weather conditions that can affect ground stability.
• Check for adequate traction if working on a slope.
6.3 Break-In Period
New machines require a break-in period to ensure maximum efficiency. Dur-
ing the break-in period, the machine’s moving parts stabilize.
This machine has a 6-hour break-in period.
To Next Page
Loading...
Need help?
General