Maintenance
7.8 Checking the Hydraulic Oil Level
76
Operator’s Manual | SM100 | 5100064108 | 08/2022 | [en-US]
2. If the engine coolant level is below the min line or above the max line,
remove the recovery reserve tank cap(2).
ð If the engine coolant level is below the min line, fill the tank with
coolant until the engine coolant level is between the min and max
lines.
ð If the engine coolant level is above the max line, use a siphon to re-
move coolant from the recovery reserve tank until the level is just at
or below the max line.
3. Install the recovery reserve tank cap.
4. Close the rear door.
7.8 Checking the Hydraulic Oil Level
Environment
Use a suitable container to collect, store, and dispose of drained fluids and
lubricants in accordance with current environmental protection regulations.
When
Every 10 hours or daily
Requirements
• Machine parked on a level surface
• Machine shut down
• Lift arm down
• New hydraulic oil as needed
Fig.58: Hydraulic oil sight glass and
access plate
Overview
The hydraulic oil filler cap and sight glass are located on the left side of the
machine.
Procedure
1. Observe the hydraulic oil level through the sight glass(1). The hy-
draulic oil level should be half full in the sight glass.
2. If the oil level is low, remove the hydraulic fill access plate by removing
the retaining bolt(2) and loosening the pivot bolt(3).
3. Rotate the access plate out of the way.
To Next Page
Loading...