Chapter 2 Dispensing to SpectroCHIP Arrays 23
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
NOTENOTE
If a user name and password has not yet been assigned, use the pre-installed user name
"researcher" and password "researcher". Note that user names and passwords are case sensitive.
See page 26 for more details on creating user names and passwords.
1. Tap the type your name box on the Login screen.
2. In the keyboard that appears, type your user name, and tap enter.
NOTENOTE
To cancel the keyboard, tap the in the upper right corner.
3. On the Login screen, tap the password box.
4. In the keyboard that appears, type the password for the user name, and tap enter.
5. On the Login screen, tap the LOGON button.
6. If a warning message appears (Figure 2.4), confirm that the user name and password
are valid. (See Table 2.2 for default user logins.)
7. Tap OK to dismiss the message and return to the Login screen.
Logging off If you choose to log off, you must log on again to access the control software.
Figure 2.3 Login Screen
Figure 2.4 Warning Screen
To Next Page
Loading...
Need help?
General