EasyManuals Logo

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 User Manual

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Chapter 2 Dispensing to SpectroCHIP Arrays 25
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
YES Saves the current instrument configuration to the DispenseCONFIG.xml file.
The parameters in the configuration file are applied at the next instrument startup. It
is usually recommended that you save the configuration file so that the instrument
uses the last configuration parameters.
If you are unsure whether parameter changes were made, or if unintentional changes
were made, press NO. The last known (and most probably good) settings will be
reloaded at the next program start.
NO The current configuration is not saved. The configuration parameters that were
last saved to the DispenseCONFIG.xml file will be used the next time the instrument
is powered on.
Figure 2.6 Prompt to Save the Configuration File

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 and is the answer not in the manual?

Agena BIOSCIENCE MassARRAY Nanodispenser RS1000 Specifications

General IconGeneral
BrandAgena BIOSCIENCE
ModelMassARRAY Nanodispenser RS1000
CategoryMeasuring Instruments
LanguageEnglish