Chapter 2 Dispensing to SpectroCHIP Arrays 47
USG-CUS-059 Rev05MassARRAY® Nanodispenser RS1000 v2.1 User Guide
For Research Use Only. Not for use in diagnostic procedures.
NOTENOTE
If the currently loaded method is a predefined method, you cannot save changes to it. Predefined
method files are read-only. Tapping SAVE in this case does not affect the method file, but will load
the changes into instrument memory (same as Apply).
.
2. Tap the run button on the Transfer screen.
To pause a run, tap the pause button . The instrument will complete the current
operation and then pause. To resume, tap the pause button again.
To abort a run, tap the stop button . Tap YES in the confirmation message that
appears.
Figure 2.40 Method Screen, aspirate/dispense tab
Figure 2.41 Transfer Screen
Note: This warning message appears
whenever you leave the Method
screen, even if no changes were made.
In that case, tap Discard.
To Next Page
Loading...