Agilent Technologies 1000B Series - To Display Cursors for Automatic Measurements

Making Measurements 4
Agilent 1000B Series Oscilloscopes User’s Guide 115
To display cursors for automatic measurements
1 Press [Cursors].
2 In the Cursors menu, press Mode.
3 Continue pressing the Mode softkey or turn the entry knob to select
“Auto”.
In the “Auto” cursors mode:
• Cursors appear for the most recently displayed automatic measurement
(see “To display an automatic measurement” on page 101).
• No cursors are displayed if there are no automatic measurements.