1290 Infinity Quaternary Pump User Manual 129
Error Information
7
Pump Error Messages
Timeout: Wait for Flow
Error ID: 29183
A target condition (flow rate) has been sent to the instrument which should
have been reached within an expected time frame but didn’t. Either the limit,
time frame or the current value of the variable has been modified later directly
or indirectly.
Timeout: Wait for Pressure
Error ID: 29185
A target condition (pressure) has been sent to the instrument which should
have been reached within an expected time frame but didn’t. Either the limit,
time frame or the current value of the variable has been modified later directly
or indirectly.
Drive Encoder failed
Error ID: 29210
Drive encoder failed during pump drive calibration.
Probable cause Suggested actions
1
Incorrect parameters have been sent to the
instrument by the control software or
manual changes.
Verify control software, macros, manual
commands.
Probable cause Suggested actions
1
Incorrect parameters have been sent to the
instrument by the control software or
manual changes.
Verify control software, macros, manual
commands.
2
Leak
Run system pressure test for identifying and
localizing the leak. Tighten leak.
Probable cause Suggested actions
1
Internal error.
Contact Agilent support.
To Next Page
Loading...
Need help?
General
