Agilent Technologies 1290 infinity User Manual

1290 Infinity Quaternary Pump User Manual 269
LAN Configuration
13
TCP/IP Parameter Configuration
TCP/IP Parameter Configuration
To operate properly in a network environment, the LAN interface must be
configured with valid TCP/IP network parameters. These parameters are:
• IP address
• Subnet Mask
• Default Gateway
The TCP/IP parameters can be configured by the following methods:
• by automatically requesting the parameters from a network-based DHCP
Server (using the so-called Dynamic Host Configuration Protocol). This
mode requires a LAN-onboard Module or a G1369C LAN Interface card, see
“Setup (DHCP)” on page 274
• by manually setting the parameters using Telnet
• by manually setting the parameters using the Instant Pilot (G4208A)
The LAN interface differentiates between several initialization modes. The
initialization mode (short form ‘init mode’) defines how to determine the
active TCP/IP parameters after power-on. The parameters may be derived
from non-volatile memory or initialized with known default values. The
initialization mode is selected by the configuration switch, see Table 15 on
page 271.

Agilent Technologies 1290 infinity Specifications

General

Brand	Agilent Technologies
Model	1290 infinity
Category	Laboratory Equipment
Language	English