Agilent Technologies 1290 infinity User Manual

1290 Infinity Quaternary Pump User Manual 275
LAN Configuration
13
Dynamic Host Configuration Protocol (DHCP)
2 Set the Configuration Switch to DHCP either on the G1369C LAN Interface
Card or the main board of above mentioned modules.
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition,
Lab Advisor, Firmware Update Tool) and use MAC address as host name,
e.g. 0030d3177321.
The LC system should become visible in the control software (see Note in
section “General Information (DHCP)” on page 273).
Tab le 1 7 G1369C LAN Interface Card (configuration switch on the card)
SW 4SW 5SW 6SW 7SW 8Initialization Mode
ON OFF OFF OFF OFF DHCP
Tab le 1 8 LC Modules with 8-bit configuration switch (B-firmware) (configuration switch
at rear of the instrument)
SW 6SW 7SW 8Initialization Mode
ON OFF OFF DHCP

Agilent Technologies 1290 infinity Specifications

General

Brand	Agilent Technologies
Model	1290 infinity
Category	Laboratory Equipment
Language	English