7-30 i3070 Series 5i Help
Install Servo Motor
3 Install the new servo motor. The shaft of the motor must be properly
aligned for it to go into the coupling. Secure the motor with the four
screws.
4 Plug in the electrical connectors.
5 Tighten the screw on the coupling.
Reposition Set Collars
6 Loosen the screws on the set collars and move them back into position,
30 mm to 50 mm from the end of the shaft. Tighten the screws on the
set collars.
7 Close all doors.
To Next Page
Loading...
