MPLS Commands
Page 142 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
retry-limit
Syntax retry-limit number
no retry-limit
Context config>router>mpls>lsp
Description This optional command specifies the number of attempts software should make to re-establish the
LSP after it has failed LSP. After each successful attempt, the counter is reset to zero.
When the specified number is reached, no more attempts are made and the LSP path is put into the
shutdown state.
Use the config router mpls lsp lsp-name no shutdown command to bring up the path after the retry-
limit is exceeded.
The no form of this command revert the parameter to the default value.
Default 0 (no limit, retries forever)
Parameters number — The number of times software will attempt to re-establish the LSP after it has failed.
Allowed values are integers in the range of 0 to 10000 where 0 indicates to retry forever.
Values 0 — 10000
retry-timer
Syntax retry-timer seconds
no retry-timer
Context config>router>mpls>lsp
Description This command configures the time, in seconds, for LSP re-establishment attempts after it has failed.
The no form of this command reverts to the default value.
Default 30
Parameters seconds — The amount of time, in seconds, between attempts to re-establish the LSP after it has
failed. Allowed values are integers in the range of 1 to 600.
Values 1 — 600
rsvp-resv-style
Syntax rsvp-resv-style [se | ff]
Context config>router>mpls>lsp
Description This command specifies the RSVP reservation style, shared explicit (se) or fixed filter (ff). A
reservation style is a set of control options that specify a number of supported parameters. The style
information is part of the LSP configuration.
Default se
To Next Page
Loading...
Need help?
General
