Alcatel-Lucent 7210 SAS M - Show Commands

LDP Command Reference
Page 270 7210 SAS M, T, X, R6, Mxp MPLS Configuration
— auth-keychain name
— authentication-key [authentication-key | hash-key] [hash |
hash2]
—no authentication-key
—[no] dod-label-distribution
—[no] export-prefixes policy-name [policy-name...(upto 5
max)]
—[no] fec129-cisco-interop
—[no] import-prefixes policy-name [policy-name...(upto 5
max)]
—[no] path-mtu-discovery
—[no] ttl-security min-ttl-value
—[no] prefer-tunnel-in-tunnel
— [no] shutdown
— targeted-session
— [no] disable-targeted-session
— hello timeout factor
—no hello
— keepalive timeout factor
—no keepalive
— peer ip-address
—no peer ip-address
— bfd-enable
—no bfd-enable
— hello timeout factor
—no hello
— keepalive timeout factor
—no keepalive
—
local-lsr-id interface-name
—no local-lsr-id
— [no] shutdown
—no tunneling
—no lsp lsp-name
— tunnel-down-damp-time seconds
—no tunnel-down-damp-time
Show Commands
show
—router
—ldp
— auth-keychain [keychain]
— bindings[fec-type fec-type [detail]] [session ip-addr[:label-space]]
— bindings [label-type] [start-label [end-label]
— bindings {prefix ip-prefix/mask [detail]}[session ip-addr[:label-space]]
— bindings active [prefix ip-prefix/mask]
— bindings service-id service-id [detail]
— bindings vc-type vc-type [{vc-id vc-id| agi agi} [session ip-addr[:lab el-space]]]
— discovery [{peer [ip-address]} | {interface [ip-int-name]}] [state state] [detail
]
— interface [ip-int-name | ip-address] [detail]
— parameters
— peer [ip-address] [detail]
— peer-parameters peer-ip-address
— session [ip-addr[:label-space]] [detail | statistics [packet-type]]
— status