Alcatel-Lucent 7210 SAS M User Manual

LDP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 297
Output LDP Discovery Output — The following table describes LDP discovery output fields.
interface
Syntax interface [ip-int-name | ip-address] [detail]
Context show>router>ldp
Description This command displays configuration information about LDP interfaces.
Parameters ip-int-name — The name of an existing interface. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
ip-address — The IP address of the LDP neighbor.
detail — Displays detailed information.
Label Description
Interface Name
The name of the interface.
Local Addr
The IP address of the originating (local) router.
Peer Addr
The IP address of the peer.
Adj Type
The adjacency type between the LDP peer and LDP session is targeted.
State
Established — The adjacency is established.
Trying — The adjacency is not yet established.
No. of Hello Adja-
cencies
The total number of hello adjacencies discovered.
Up Time
The amount of time the adjacency has been enabled.
Hold-Time Remain-
ing
The time left before a neighbor is declared to be down.
Hello Mesg Recv
The number of hello messages received for this adjacency.
Hello Mesg Sent
The number of hello messages that have been sent for this adjacency.
Remote Cfg Seq No
The configuration sequence number that was in the hello received
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
Remote IP Address
The IP address used on the remote end for the LDP session.
Local Cfg Seq No
The configuration sequence number that was used in the hello sent
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
Local IP Address
The IP address used locally for the LDP session.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English