Alcatel-Lucent 7210 SAS M - Targeted Session Parameters

Common Configuration Tasks
Page 260 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Targeted Session Parameters
Use the following syntax to specify targeted-session parameters:
CLI Syntax: config>router# ldp
targeted-session
disable-targeted-session
hello timeout factor
keepalive timeout factor
peer ip-address
no bfd-enable
hello timeout factor
keepalive timeout factor
no shutdown
The following example displays an LDP configuration example:
A:ALA-1>config>router>ldp# info
----------------------------------------------
...
targeted-session
hello 5000 255
keepalive 5000 255
peer 10.10.10.104
no bfd-enable
hello 2500 104
keepalive 15 3
exit
exit
----------------------------------------------
A:ALA-1>config>router>ldp#