Alcatel-Lucent 7210 SAS M - Configuring a Static LSP

Common Configuration Tasks
Page 88 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Configuring a Static LSP
An LSP can be explicitly (statically) configured. Static LSPs are configured on every node
along the path. The label’s forwarding information includes the address of the next hop router.
Use the following CLI syntax to configure a static LSP:
CLI Syntax: config>router>mpls
static-lsp lsp-name
to ip-address
push out-label nexthop ip-addr
no shutdown
The following displays a static LSP configuration example:
A:ALA-1>config>router>mpls# info
----------------------------------------------
...
static-lsp "static-LSP"
to 10.10.10.124
push 60 nexthop 10.10.42.3
no shutdown
exit
...
----------------------------------------------
A:ALA-1>config>router>mpls#