Alcatel-Lucent 7210 SAS M - Modifying Interface Parameters

Label Distribution Protocol
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 267
Modifying Interface Parameters
The modification of LDP targeted session parameters does not take effect until the next time the
session goes down and is re-establishes. Individual parameters cannot be deleted. The no form of
a interface-parameter command reverts modified values back to the defaults.
The following output displays the default values:
A:ALU_SIM11>config>router>ldp>targ-session# info detail
----------------------------------------------
no disable-targeted-session
hello 45 3
keepalive 40 4
----------------------------------------------
A:ALU_SIM11>config>router>ldp>targ-session#