Alcatel-Lucent 7210 SAS M - Configuring MPLS Paths

Common Configuration Tasks
Page 86 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Configuring MPLS Paths
Configure an LSP path to use in MPLS. When configuring an LSP, the IP address of the hops
that the LSP should traverse on its way to the egress router must be specified. The
intermediate hops must be configured as either strict or loose meaning that the LSP must take
either a direct path from the previous hop router to this router (strict) or can traverse through
other routers (loose).
Use the following CLI syntax to configure a path:
CLI Syntax: config>router> mpls
path path-name
hop hop-index ip-address {strict|loose}
no shutdown
pathconfi g
The following displays a path configuration example:
A:ALA-1>config>router>mpls# info
------------------------------------------
interface "system"
exit
path "secondary-path"
hop 1 10.10.0.121 strict
hop 2 10.10.0.145 strict
hop 3 10.10.0.1 strict
no shutdown
exit
path "to-NYC"
hop 1 10.10.10.103 strict
hop 2 10.10.0.210 strict
hop 3 10.10.0.215 loose
exit
------------------------------------------
A:ALA-1>config>router>mpls#