Alcatel-Lucent 7210 SAS M - RSVP Configuration Management Tasks; Modifying RSVP Parameters

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 99
RSVP Configuration Management Tasks
This section discusses the following RSVP configuration management tasks:
• Modifying RSVP Parameters on page 99
• Modifying RSVP Message Pacing Parameters on page 100
• Deleting an Interface from RSVP on page 100
Modifying RSVP Parameters
Only interfaces configured in the MPLS context can be modified in the RSVP context.
The no rsvp command deletes this RSVP protocol instance and removes all configuration
parameters for this RSVP instance.
The shutdown command suspends the execution and maintains the existing configuration.
The following example displays a modified RSVP configuration example:
A:ALA-1>config>router>rsvp# info
----------------------------------------------
keep-multiplier 5
refresh-time 60
msg-pacing
period 400
max-burst 400
exit
interface "system"
exit
interface "test1"
hello-interval 5000
exit
no shutdown
----------------------------------------------
A:ALA-1>config>router>rsvp#