Alcatel-Lucent 7210 SAS M User Manual

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 83
Common Configuration Tasks
This section provides a brief overview of the tasks to configure MPLS and provides the CLI
commands.
The following protocols must be enabled on each participating router.
•MPLS
• RSVP (for RSVP-signaled MPLS only)
•LDP
In order for MPLS to run, you must configure at least one MPLS interface in the
config>router>mpls context.
• An interface must be created in the config>router>interface context before it can be
applied to MPLS.
•In the config>router>mpls context, configure path parameters for configuring LSP
parameters. A path specifies some or all hops from ingress to egress. A path can be
used by multiple LSPs.
• When an LSP is created, the egress router must be specified in the to command and at
least one primary or secondary path must be specified. All other statements under the
LSP hierarchy are optional.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English