Alcatel-Lucent 7210 SAS M - LDP Command Reference

LDP Command Reference
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 269
LDP Command Reference
Command Hierarchies
• LDP Commands on page 269
• Show Commands on page 270
• Clear Commands on page 271
• Debug Commands on page 271
LDP Commands
config
—router
— [no] ldp
— [no] aggregate-prefix-match
— prefix-exclude policy-name [policy-name...(up to 5 max)]
—no prefix-exclude
— [no] shutdown
— export policy-name [policy-name...(up to 5 max)]
—no export
— fast-reroute
—no fast-reroute
— [no] graceful-restart
— maximum-recovery-time interval
—no maximum-recovery-time
— neighbor-liveness-time interval
—no neighbor-liveness-time
— [no] implicit-null-label
— import policy-name [policy-name...(up to 5 max)]
— interface-parameters
— hello timeout factor
—no hello
— [no] interface ip-int-name
— bfd-enable
—no bfd-enable
— hello timeout factor
—no hello
— keepalive timeout factor
—no keepalive
— local-lsr-id {system | interface}
— no local-lsr-id
— [no] shutdown
— transport-address {system | interface}
— keepalive timeout factor
—no keepalive
— transport-address {system | interface}
— label-withdrawal-delay seconds
— peer-parameters
— peer ip-address
—no peer [ip-address]