Alcatel-Lucent 7210 SAS M - Page 273

LDP Configuration Commands
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 273
LDP Configuration Commands
Generic Commands
ldp
Syntax [no] ldp
Context config>router
Default This command creates the context to configure an LDP parameters. LDP is not enabled by default and
must be explicitely enabled (no shutdown).
To suspend the LDP protocol, use the shutdown command. Configuration parameters are not
affected.
The no form of the command deletes the LDP protocol instance, removing all associated
configuration parameters. The LDP instance must first be disabled with the shutdown command
before being deleted.
Default none (LDP must be explicitly enabled)
shutdown
Syntax [no] shutdown
Context config>router>ldp
config>router>ldp>targ-session>peer
config>router>ldp>interface
config>router>ldp>aggregate-prefix-match
Description This command administratively disables an entity. When disabled, an entity does not change, reset, or
remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
The no form of this command administratively enables an entity.
Unlike other commands and parameters where the default state is not indicated in the configuration
file, the shutdown and no shutdown states are always indicated in system generated configuration
files.
The no form of the command places an entity in an administratively enabled state.
Default no shutdown