Alcatel-Lucent 7210 SAS M - MPLS Path Commands; MPLS-TP LSP Commands (Supported on 7210 SAS-R6 and 7210 SAS-T)

MPLS/RSVP Command Reference
Page 106 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
MPLS-TP LSP Commands (Supported on 7210 SAS-R6 and 7210 SAS-T)
config
—router
— [no] mpls
— [no] lsp lsp-name [bypass-only | mpls-tp src-tunnel-num]
— [no] protect-tp-path
— in-label in-label
— lsp-num lsp-number
—no lsp-num
— [no] mep
— bfd-enable [bfd-mode]
—no bfd-enable
— oam-template [32 chars max]
—no oam-template
— protection-template 256 chars max
—no protection-template
— [no] shutdown
— out-label out-label out-link if-name [next-hop ip-address]
—no out-label
— [no] shutdown
— [no] working-tp-path
— in-label in-label
— lsp-num lsp-number
—no lsp-num
— [
no] mep
— bfd-enable [bfd-mode]
—no bfd-enable
— oam-template name
—no oam-template
— [no] shutdown
— out-label out-label out-link if-name [next-hop ip-address]
—no out-label
— [no] shutdown
MPLS Path Commands
config
—router
— [no] mpls
— [no] path path-name
— hop hop-index ip-address {strict | loose}
—no hop hop-index
— [no] shutdown
— [no] static-lsp lsp-name
— push label nexthop ip-address
—no push out-label
— to ip-addr
— [no] shutdown