EasyManuals Logo

Alcatel-Lucent 7210 SAS M User Manual

Alcatel-Lucent 7210 SAS M
321 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 151
(G-ACh) on the path. The timer parameters of the BFD session are taken from the the OAM template
of the MEP.
A value of cc means that the BFD session is only used for continuity check of the the MPLS-TP path.
In this case, the cc timer parameters of the OAM template apply. A value of cv means that the BFD
session is used for both continuity checking and connectivity verification, and the cv timers of the
OAM template apply.
This form of the bfd-enable command is only applicable when it is configured under a MEP used on
an MPLS-TP working or protect path.
Default no bfd-enable
Parameters cc | cc_cv — cc indicates that BFD runs in CC only mode. This mode uses GACh channel type 0x07.
cc_cv indicates that BFD runs in combined CC and CV mode. This mode uses channel type 0x22
for MPLS-TP CC packets, and 0x23 for MPLS-TP CV packets.
protection-template
Syntax protection-template name
no protection-template
Context config>mpls>lsp>protect-tp-path
Description This command applies a protection template name to an MPLS-TP LSP that the protect path is
configured under. If the template is applied, then MPLS-TP 1:1 linear protection is enabled on the
LSP, using the parameters specified in the named template.
A named protection template can only be applied to the protect path context of an MPLS-TP LSP.
The no form of the command removes the template and thus disables mpls-tp linear protection on the
LSP.
Default no protection-template
Parameters name — Specifies at text string for the template up to 32 characters in printable 7-bit ASCII, enclosed
in double quotes.
bandwidth
Syntax bandwidth rate-in-mbps
no bandwidth
Context config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description This command specifies the amount of bandwidth to be reserved for the LSP path.
The no form of this command resets bandwidth parameters (no bandwidth is reserved).
Default no bandwidth (bandwidth setting in the global LSP configuration)

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent 7210 SAS M and is the answer not in the manual?

Alcatel-Lucent 7210 SAS M Specifications

General IconGeneral
BrandAlcatel-Lucent
Model7210 SAS M
CategorySwitch
LanguageEnglish

Related product manuals