Alcatel-Lucent 7210 SAS M - Page 152

MPLS Commands
Page 152 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
Parameters rate-in-mbps — The amount of bandwidth reserved for the LSP path in Mbps. Allowed values are
integers in the range of 1 to 100000.
Values 0 — 100000
exclude
Syntax [no] exclude group-name [group-name...(up to 5 max)]
Context config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description This command specifies the admin groups to be excluded when an LSP is set up. . Up to 5 groups per
operation can be specified, up to 32 maximum. The admin groups are defined in the
config>router>mpls>admin-group context.
Use the no form of the command to remove the exclude command.
Default no exclude
Parameters group-name — Specifies the existing group-name to be excluded when an LSP is set up.
hop-limit
Syntax hop-limit number
no hop-limit
Context config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description This optional command overrides the config router mpls lsp lsp-name hop-limit command. This
command specifies the total number of hops that an LSP traverses, including the ingress and egress
routers.
This value can be changed dynamically for an LSP that is already set up with the following
implications:
If the new value is less than the current hops of the established LSP, the LSP is brought down. MPLS
then tries to re-establish the LSP within the new hop-limit number. If the new value is equal or more
than the current hops of the established LSP then the LSP will be unaffected.
The no form of this command reverts the values defined under the LSP definition using the config
router mpls lsp lsp-name hop-limit command.
Default no hop-limit
Parameters number — The number of hops the LSP can traverse, expressed as an integer.
Values 2 — 255