Alcatel-Lucent 7210 SAS M User Manual

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 91
Configuring RSVP Parameters
RSVP is used to set up LSPs. RSVP must be enabled on the router interfaces that are
participating in signaled LSPs. The keep-multiplier and refresh-time default values can be
modified in the RSVP context.
Initially, interfaces are configured in the config>router>mpls>interface context. Only these
existing (MPLS) interfaces are available to modify in the config>router> rsvp context.
Interfaces cannot be directly added in the RSVP context.
The following example displays an RSVP configuration example:
rsvp config
A:ALA-1>config>router>rsvp# info
----------------------------------------------
interface "system"
no shutdown
exit
interface to-104
hello-interval 4000
no shutdown
exit
no shutdown
----------------------------------------------
A:ALA-1>config>router>rsvp#

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English