EasyManua.ls Logo

Alcatel-Lucent 7210 SAS M - LER Configuration for MPLS-TP; LSP and Path Configuration

Alcatel-Lucent 7210 SAS M
321 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MPLS Transport Profile (MPLS-TP)
Page 52 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
mac <local-mac-address>
static-arp <remote-mac-addr>
//ieee-address needs to support mcast and bcast
exit
The remote-mac-address may be any unicast, broadcast of multicast address. However, a
broadcast or multicast remote-mac-address is only allowed in the static-arp command on Ethernet
unnumbered interfaces when the unnumbered-mpls-tp keyword has been configured. This also
allows the interface to accept packets on a broadcast or any multicast MAC address. Note that if a
packet is received with a unicast destination MAC address, then it will be checked against the
configured <local-mac-address> for the interface, and dropped if it does not match. When an
interface is of type unnumbered-mpls-tp, only MPLS-TP LSPs are allowed on that interface;
other protocols are blocked from using the interface.
An unnumbered MPLS-TP interface is assumed to be point-to-point, and therefore users must
ensure that the associated link is not broadcast or multicast in nature if a multicast or broadcast
remote MAC address is configured.
The following is a summary of the constraints of an unnumbered MPLS-TP interface:
It is unnumbered and may borrow/use the system interface address
It prevents explicit configuration of a borrowed address
It prevents IP address configuration
It prevents all protocols except MPLS
It prevents Deletion if an MPLS-TP LSP is bound to the Interface
It is allowed only in network chassis mode D
MPLS-TP is only supported over Ethernet ports. The system will block the association of an
MPLS-TP LSP to an interface whose port is non-Ethernet.
LER Configuration for MPLS-TP
LSP and Path Configuration
MPLS-TP tunnels are configured using the mpls-tp LSP type at an LER under the LSP
configuration, using the following CLI tree:
config
router
mpls
lsp <xyz> [bypass-only|mpls-tp <src-tunnel-num>]
to node-id {<a.b.c.d> | <1.. .4,294,967,295>}
dest-global-id <global-id>
dest-tunnel-number <tunnel-num>

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Related product manuals