Alcatel-Lucent 7210 SAS M - Modifying Targeted Session Parameters

LDP Configuration Management Tasks
Page 266 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Modifying Targeted Session Parameters
The modification of LDP targeted session parameters does not take effect until the next time the
session goes down and is re-establishes. Individual parameters cannot be deleted. The
no form of a
targeted-session parameter command reverts modified values back to the default.
The following example displays the command syntax usage to revert targeted session parameters
back to the default values:
Example: config>router# ldp
config>router>ldp# targeted-session
config>router>ldp>targeted# no authentication-key
config>router>ldp>targeted# no disable-targeted-session
config>router>ldp>targeted# no hello
config>router>ldp>targeted# no keepalive
config>router>ldp>targeted# no peer 10.10.10.99
The following output displays the default values:
A:ALA-1>config>router>ldp>targeted# info detail
----------------------------------------------
no disable-targeted-session
hello 45 3
keepalive 40 4
----------------------------------------------
A:ALA-1>config>router>ldp>targeted#