Alcatel-Lucent 7210 SAS M - MPLS;RSVP Command Reference; Command Hierarchies; MPLS Commands

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 101
MPLS/RSVP Command Reference
Command Hierarchies
• MPLS Commands on page 101
• MPLS Path Commands on page 106
• MPLS-TP Commands (Supported on 7210 SAS-R6 and 7210 SAS-T network mode devices) on
page 103
• MPLS LSP Commands on page 104
• RSVP Commands on page 107
• Show Commands on page 108
• Clear Commands on page 109
• Debug Commands on page 110
MPLS Commands
config
—router
— [no] mpls
— admin-group group-name group-value
—no admin-group group-name
— dynamic-bypass [enable | disable]
— [no] frr-object
— hold-timer seconds
—no hold-timer
— [no] interface ip-int-name
— [no] admin-group group-name [group-name...(up to 5 max)]
— label-map in-label
—no label-map in-label
—no pop
— pop
—no shutdown
— shutdown
— swap out-label nexthop ip-address
— swap implicit-null-label nexthop ip-address
—no swap
—no shutdown
— shutdown
—[no] srlg-group group-name [group-name...(up to 5 max)]
— te-metric metric
—no te-metric
— resignal-timer minutes
—no resignal-timer
— [no] shutdown