Alcatel-Lucent 7210 SAS M - Page 103

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 103
MPLS-TP Commands (Supported on 7210 SAS-R6 and 7210 SAS-T network
mode devices)
config
—router
— [no] mpls
— [no] mpls-tp
— global-id global-id
—no global-id
— node-id node-id
—no node-id
— [no] oam-template name
— bfd-template name
—no bfd-template
— hold-time-down timer
—no hold-time-down
— hold-time-up timer
—no hold-time-up
— protection-template name
—no protection-template
— rapid-psc-timer interval
—no rapid-psc-timer
— [no] revertive
— slow-psc-timer interval
—no slow-psc-timer
— wait-to-restore interval
—no wait-to-restore
— [no] shutdown
— tp-tunnel-id-range start-id end-id
—no tp-tunnel-id-range
— transit-path path-name
—no transit-path
— [no] forward-path in-label out-label out-label out-link inter-
face name [next-hop ip-address]
— in-label in-label out-label out-label out-link if-name
[next-hop next-hop]
— path-id {lsp-num lsp-num | working-path | protect-path [src-
global-id src-global-id] src-node-id src-node-id src-tunnel-
num src-tunnel-num [dest-global-id dest-global-id] dest-node-
id dest-node-id [dest-tunnel-num dest-tunnel-num]}
—no path-id
— [no] reverse-path in-label out-label out-label out-link interface
name [next-hop ip-address]
— in-label in-label out-label out-label out-link if-name
[next-hop next-hop]
— [no] shutdown