MPLS Commands
Page 132 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
The no form of the command removes the path ID from the configuration.
Default no path-id
Parameters lsp-num — Specifues the LSP number.
Values 1 — 65535, or working path, or protect-path. A working-path is equivalent to a
lsp-num of 1, and a protect-path is an lsp-num of 2.
src-global-id — Specifies the source global ID.
Values 0 — 4294967295
src-node-id — Specifies the source node ID.
Values a.b.c.d or 1 — 4294967295
src-tunnel-num — Specifies the source tunnel number.
Values 1 — 61440
dest-global-id — Specifies the destination global ID. If the destination global ID is not entered, then
it is set to the same value as the source global ID.
Values 0 — 4294967295
dest-node-id — Specifies the destination node ID.
Values a.b.c.d or 1 — 4294967295
dest-tunnel-num — Specifies the destination tunnel number. If the destination tunnel number is not
entered, then it is set to the same value as the source tunnel number.
Values 1 — 61440
forward-path
Syntax [no] forward-path
Context config>router>mpls>mpls-tp>transit-path
Description Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
This command enables the forward path of an MPLS-TP transit path to be created or edited.
The forward path must be created before the reverse path.
The no form of this command removes the forward path. The forward path cannot be removed if a
reverse exists.
Default no forward-path
To Next Page
Loading...
Need help?
General
