Alcatel-Lucent 7210 SAS M - Peer Parameters Commands

Label Distribution Protocol
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 263
Peer Parameters
Use the following syntax to specify interface parameters:
CLI Syntax: config>router# ldp
peer-parameters
peer ip-address
auth-keychain name
authentication-key [authentication-key|hash-key]
[hash|hash2]
A:ALA-1>config>router>ldp# info
----------------------------------------------
peer-parameters
peer 10.10.10.104
authentication-key "3WErEDozxyQ" hash
exit
exit
targeted-session
hello 5000 255
keepalive 5000 255
peer 10.10.10.104
no bfd-enable
hello 2500 100
keepalive 15 3
exit
exit
----------------------------------------------
A:ALA-1>config>router>ldp#