MPLS Commands
Page 130 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
slow-psc-timer
Syntax slow-psc-timer interval
no slow-psc-timer
Context config>router>mpls>mpls-tp>protection-template
Description Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
This command configures the slow timer value to be used for protection switching coordination
(PSC) packets for MPLS-TP linear protection (RFC 6378).
Default no rapid-psc-timer
Parameters interval — Specifies the slow timer interval.
Values [10, 100, 1000 ms]
global-id
Syntax global-id global-id
no global-id
Context config>router>mpls>mpls-tp
Description Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
This command configures the MPLS-TP Global ID for the node. This is used as the ‘from’ Global ID
used by MPLS-TP LSPs originating at this node. If a value is not entered, the Global ID is taken to be
Zero. This is used if the global-id is not configured. If an operator expects that inter domain LSPs will
be configured, then it is recommended that the global ID should be set to the local ASN of the node,
as configured under config>system. If two-byte ASNs are used, then the most significant two bytes
of the global-id are padded with zeros.
In order to change the value of the global-id, config>router>mpls>mpls-tp must be in the shutdown
state. This will bring down all of the MPLS-TP LSPs on the node. New values a propagated to the
system when a no shutdown is performed.
Default no global-id
Parameters global-id — Specifies the global ID for the node.
Values 0 — 4294967295
node-id
Syntax node-id node-id
no node-id
Context config>router>mpls>mpls-tp
Description Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.