MPLS Commands
Page 150 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
oam-template
Syntax oam-template name
no oam-template
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command applies a OAM template to an MPLS-TP working or protect path. It contains
configuration paraeters for proactive OAM mechanisms that can be enabled on the path e.g. BFD.
Configuration of an OAM template is optional.
The no form of the command removes the OAM template from the path.
Default no oam-template
Parameters name — Speciifes a text string name for the template up to 32 characters in printable 7-bit ASCII,
enclosed in double quotes.
shutdown
Syntax [no] shutdown
Context config>mpls>lsp>working-tp-path>mep
config>mpls>lsp>protect-tp-path>mep
config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command disables the existing LSP including the primary and any standby secondary paths.
To shutdown only the primary enter the config router mpls lsp lsp-name primary path-name
shutdown command.
To shutdown a specific standby secondary enter the config router mpls lsp lsp-name secondary path-
name shutdown command. The existing configuration of the LSP is preserved.
Use the no form of this command to restart the LSP. LSPs are created in a shutdown state. Use this
command to administratively bring up the LSP.
Default shutdown
bfd-enable
Syntax bfd-enable [bfd-mode]
no bfd-enable
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description The command associates the operational state of an MPLS-TP path with a BFD session whose
control packets flow on the path. The BFD packets are encapsulated in a generic associated channel
To Next Page