Alcatel-Lucent 7210 SAS M - Page 149

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 149
out-label
Syntax out-label out-label out-link if-name [next-hop ip-address]
no out-label
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configureds the outgoing label value to use for an MPLS-TP working or protect path.
The out-link is the outgoing interface on the node that this path will use, and must be specified. If the
out-link refers to a numbered IP interface, the user may optionally configure the next-hop parameter
and the system will determine the interface to use to reach the configured next-hop, but will check
that the user-entered value for the out-link corresponds to the link returned by the system. If they do
not correspond, then the path will not come up.
Default no out-label
Parameters out-label — Specifies the out label.
Values 32 — 16415
if-name — Specifies the interface name.
ip-address — Specifies the IPv4 address in a.b.c.d
mep
Syntax [no] mep
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command creates or edits an MPLS-TP maintenance entity group (MEG) endpoint (MEP) on
and MPLS-TP path. MEPs reporesent the termination point for OAM flowing on the path, as well as
linear protection for the LSP. Only one MEP can be configured at each end of the path.
The following commands are applicable to a MEP on an MPLS-TP working or protect path: oam-
template, bfd-enable, and shutdown. In addition, a protection-template may be configured on a
protect path.
The no form of the command removes a MEP from an MPLS-TP path.