Alcatel-Lucent 7210 SAS M User Manual

MPLS Commands
Page 148 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
must be deleted before the wokring path. Only one protect path can be created for each MPLS-TP
LSP.
The following commands are applicable to the working-tp-path: lsp-num, in-label, out-label, mep,
and shutdown.
lsp-num
Syntax lsp-num lsp-num
no lsp-num
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configures the MPLS-TP LSP Number for the working TP path or the Protect TP
Path.
Default no lsp-num
Parameters lsp-num — Specifies the LSP number.
Values 1 — 65535
Default 1 for a working path, 2 for a protect path
in-label
Syntax in-label in-label
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configures the incoming label for the reverse path or the working path or the protect
path of an MPLS-TP LSP. MPLS-TP LSPs are bidirectional, and so an incoming label value must be
specified for each path.
Default no in-label
Parameters in-label — Specifies the in label.
Values 32 — 16415

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English