Alcatel-Lucent 7210 SAS M - Page 161

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 161
shutdown
Syntax [no] shutdown
Context config>router>mpls>static-lsp
Description This command is used to administratively disable the static LSP.
The no form of this command administratively enables the static LSP.
Default shutdown
to
Syntax to ip-address
Context config>router>mpls>static-lsp
Description This command specifies the system IP address of the egress router for the static LSP. When creating
an LSP this command is required. For LSPs that are used as transport tunnels for services, the to IP
address must be the system IP address.
Parameters ip-address — The system IP address of the egress router.
Default none