Alcatel-Lucent 7210 SAS M User Manual

Targeted Session Commands
Page 290 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
Targeted Session Commands
targeted-session
Syntax targeted-session
Context config>router>ldp
Description This command configures targeted LDP sessions. Targeted sessions are LDP sessions between non-
directly connected peers. Hello messages are sent directly to the peer platform instead of to all the
routers on this subnet multicast address.
The discovery messages for an indirect LDP session are addressed to the specified peer and not to the
multicast address.
Default none
disable-targeted-session
Syntax [no] disable-targeted-session
Context config>router>ldp>targ-session
Description This command disables support for SDP triggered automatic generated targeted sessions. Targeted
sessions are LDP sessions between non-directly connected peers. The discovery messages for an
indirect LDP session are addressed to the specified peer and not to the multicast address.
The no form of the command enables the set up of any targeted sessions.
Default no disable-targeted-session
peer
Syntax [no] peer ip-address
Context config>router>ldp>targeted-session
Description This command configures parameters for an LDP peer.
Default none
Parameters ip-address — The IP address of the LDP peer in dotted decimal notation.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English