LDP Configuration Commands
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 285
Peer Parameters Commands
peer-parameters
Syntax peer-parameters
Context config>router>ldp
Description This command enables the context to configure peer specific parameters.
peer
Syntax [no] peer ip-address
Context config>router>ldp>peer-parameters
Description This command configures parameters for an LDP peer.
Default none
Parameters ip-addr — The IP address of the LDP peer in dotted decimal notation.
auth-keychain
Syntax auth-keychain name
Context config>router>ldp>peer-parameters>peer
Description This command configures TCP authentication keychain to use for the session.
Parameters name — Specifies the name of the keychain to use for the specified TCP session or sessions. This
keychain allows the rollover of authentication keys during the lifetime of a session up to 32
characters in length. Peer address has to be the TCP session transport address.
authentication-key
Syntax authentication-key [authentication-key | hash-key] [hash | hash2]
no authentication-key
Context config>router>ldp>peer-parameters>peer
Description This command specifies the authentication key to be used between LDP peers before establishing
sessions. Authentication uses the MD-5 message-based digest. Peer address has to be the TCP session
transport address.
The no form of this command disables authentication.
To Next Page
Loading...
