Alcatel-Lucent 7210 SAS M - Page 296

Show Commands
Page 296 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
A - Apipe Service, F - Fpipe Service, I - IES Service, R - VPRN service
P - Ipipe Service, WP - Label Withdraw Pending, C - Cpipe Service
TLV - (Type, Length: Value)
===============================================================================
LDP Prefix Bindings
===============================================================================
Prefix Peer IngLbl EgrLbl EgrIntf/ EgrNextHop
LspId
-------------------------------------------------------------------------------
1.1.1.1/32 1.1.1.1 -- 131071 1/1/1 6.6.6.1
1.1.1.2/32 1.1.1.1 131071U -- -- --
-------------------------------------------------------------------------------
No. of Prefix Bindings: 2
===============================================================================
LDP Service FEC 128 Bindings
===============================================================================
Type VCId SvcId SDPId Peer IngLbl EgrLbl LMTU RMTU
-------------------------------------------------------------------------------
No Matching Entries Found
===============================================================================
LDP Service FEC 129 Bindings
===============================================================================
AGI SAII TAII
Type SvcId SDPId Peer IngLbl EgrLbl LMTU RMTU
-------------------------------------------------------------------------------
No Matching Entries Found
===============================================================================
*A:ALU_SIM11>show>router>ldp#
discovery
Syntax discovery [{peer [ip-address]} | {interface [ip-int-name]}] [state state] [detail] [adjacency-
type type]
Context show>router>ldp
Description This command displays the status of the interfaces participating in LDP discovery.
Parameters peer ip-address — Specifies to display the IP address of the peer.
interface ip-int-name — The name of an existing interface. If the string contains special characters
(#, $, spaces, etc.), the entire string must be enclosed within double quotes.
state state — Specifies to display the current operational state of the adjacency.
Values established, trying, down
detail — Specifies to display detailed information.
adjacency-type type — Specifies to display the adjacency type.
Values link, targeted