Alcatel-Lucent 7210 SAS M - Page 303

LDP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 303
-------------------------------------------------------------------------------
Peer 10.8.100.15
-------------------------------------------------------------------------------
Admin State : Up Oper State : Up
Hold Time : 45 Hello Factor : 3
Keepalive Timeout : 40 Keepalive Factor : 4
Passive Mode : Disabled Last Modified : 03/03/2010 19:47:34
Active Adjacencies : 1 Auto Created : No
Tunneling : Disabled
Lsp Name : None
Local LSR : None
BFD Status : Disabled
===============================================================================
*A:SRU4>config>router>ldp#
peer-parameters
Syntax peer-parameters peer-ip-address
Context show>router>ldp
Description This command displays LDP peer information.
Parameters peer-ip-address — Specify the peer IP address.
LDP peer-parameters output — The following table describes LDP peer-parameters output.
Sample Output
7210SAS# show router ldp peer-parameters
===============================================================================
LDP Peers
===============================================================================
-------------------------------------------------------------------------------
Peer : 3.3.3.3
-------------------------------------------------------------------------------
TTL Security : Disabled Min-TTL : n/a
Authentication Key : Disabled DOD : Enabled
Auth key chain : n/a
Label Description
Peer
The IP address of the peer.
TTL security
Enabled — LDP peering sessions protected.
Disabled — LDP peering sessions unprotected.
Min-TTL-Value
Displays the minimum TTL value for an incoming packet.
Auth
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.