RSVP Commands
Page 166 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
rapid-retry-limit
Syntax rapid-retry-limit limit
no rapid-retry-limit
Context config>router>rsvp
Description This command is used to define the value of the Rapid Retry Limit. This is used in the retransmission
mechanism based on an exponential backoff timer in order to handle unacknowledged message_id
objects. The RSVP message with the same message_id is retransmitted every 2 * rapid-retransmit-
time interval of time. The node will stop retransmission of unacknowledged RSVP messages
whenever the updated backoff interval exceeds the value of the regular refresh interval or the number
of retransmissions reaches the value of the rapid-retry-limit parameter, whichever comes first.
The no form of this command reverts to the default value.
Default 3
Parameters limit — Specifies the value of the Rapid Retry Limit.
Values 1 – 6, integer values
refresh-time
Syntax refresh-time seconds
no refresh-time
Context config>router>rsvp
Description The refresh-time controls the interval, in seconds, between the successive Path and Resv refresh
messages. RSVP declares the session down after it misses keep-multiplier number consecutive
refresh messages.
The no form of this command reverts to the default value.
Default 30 seconds
Parameters seconds — The refresh time in seconds.
Values 1 — 65535
To Next Page
Loading...
Need help?
General
