Alcatel-Lucent 7210 SAS M User Manual

Show Commands
Page 190 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
4659 4659 src-1.9
4660 4660 src-1.10
-------------------------------------------------------------------------------
No. of Groups: 30
===============================================================================
*A:SRU4>config>router>mpls#
*A:SRU4>config>router>mpls# show router mpls srlg-group "1432"
===============================================================================
MPLS Srlg Groups
===============================================================================
Group Name Group Value Interfaces
-------------------------------------------------------------------------------
1432 1432 srl-1
-------------------------------------------------------------------------------
No. of Groups: 1
===============================================================================
*A:SRU4>config>router>mpls#
static-lsp
Syntax static-lsp [lsp-name]
static-lsp {transit | terminate}
static-lsp count
Context show>router>mpls
Description This command displays MPLS static LSP information.
Output MPLS Static LSP Output — The following table describes MPLS static LSP output fields.
Label Description
Lsp Name
The name of the LSP used in the path.
To
The system IP address of the egress router for the LSP.
Next Hop
The system IP address of the next hop in the LSP path.
In I/F
The ingress interface.
Out Label
The egress interface.
Out I/F
The egress interface.
Adm
Down — The path is administratively disabled.
Up — The path is administratively enabled.
Opr
Down — The path is operationally down.
Up — The path is operationally up.
LSPs
The total number of static LSPs.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English