Alcatel-Lucent 7210 SAS M - Page 199

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 199
TE6-> Resv. Bw : 0 Unresv. Bw : 0
TE7-> Resv. Bw : 0 Unresv. Bw : 0
No Neighbors.
===============================================================================
neighbor
Syntax neighbor [ip-address] [detail]
Context show>router>rsvp
Description This command shows neighbor information.
Parameters ip-address — Displays RSVP information about the specified IP address.
detail — Displays detailed information.
session
Syntax session session-type [from ip-address | to ip-address| lsp-name name] [status {up |
down}] [detail]
Context show>router>rsvp
Description This command shows RSVP session information.
Parameters session session-type — Specifies the session type.
Values originate, transit, terminate, detour, detour-transit, detour-terminate, bypass-tunnel,
manual-bypass
from ip-address — Specifies the IP address of the originating router.
to ip-address — Specifies the IP address of the egress router.
lsp-name name — Specifies the name of the LSP used in the path.
status up — Specifies to display a session that is operationally up.
status down — Specifies to display a session that is operationally down.
detail — Displays detailed information.
Output RSVP Session Output — The following table describers RSVP session output fields.
Label Description
From
The IP address of the originating router.
To
The IP address of the egress router.
Tunnel ID
The IP address of the tunnel’s ingress node supporting this RSVP ses-
sion.