Alcatel-Lucent 7210 SAS M - Page 210

Debug Commands
Page 210 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Debug Commands
mpls
Syntax mpls [lsp lsp-name] [sender source-address] [endpoint endpoint-address] [tunnel-id tun-
nel-id] [lsp-id lsp-id]
no mpls
Context debug>router
Description This command enables and configures debugging for MPLS.
Parameters lsp lsp-name — Name that identifies the LSP. The LSP name can be up to 32 characters long and
must be unique.
sender source-address — The system IP address of the sender.
endpoint endpoint-address — The far-end system IP address.
tunnel-id tunnel-id — The MPLS SDP ID.
Values 0 — 4294967295
lsp-id lsp-id — The LSP ID.
Values 1 — 65535
interface ip-int-name — Name that identifies the interface. The interface name can be up to 32
characters long and must be unique. If the string contains special characters (#, $, spaces, etc.),
the entire string must be enclosed within double quotes.
event
Syntax [no] event
Context debug>router>mpls
debug>router>rsvp
Description This command enables debugging for specific events.
The no form of the command disables the debugging.