Alcatel-Lucent 7210 SAS M - Page 301

LDP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 301
Sample Output
*A:SRU4>config>router>ldp# show router ldp peer
===============================================================================
LDP Peers
===============================================================================
Peer Adm Opr Hello Hold KA KA Passive Auto
Factor Time Factor Timeout Mode Created
-------------------------------------------------------------------------------
10.8.100.15 Up Up 3 45 4 40 Disabled No
10.20.1.20 Up Up 3 45 4 40 Disabled No
10.20.1.22 Up Up 3 45 4 40 Disabled No
10.100.1.1 Up Up 3 45 4 40 Disabled No
110.20.1.1 Up Up 3 45 4 40 Disabled No
110.20.1.2 Up Up 3 45 4 40 Disabled No
110.20.1.3 Up Up 3 45 4 40 Disabled No
110.20.1.5 Up Up 3 45 4 40 Disabled No
110.20.1.6 Up Up 3 45 4 40 Disabled No
110.20.1.51 Up Up 3 45 4 40 Disabled No
110.20.1.52 Up Up 3 45 4 40 Disabled No
Hold Time
The hello time or hold time. The time interval, in seconds, that LDP
waits before declaring a neighbor to be down. Hello timeout is local to
the system and is sent in the hello messages to a neighbor.
KA Factor
The value by which the keepalive timeout should be divided to give the
keepalive time, for example, the time interval, in seconds,
between LDP keepalive messages. LDP keepalive messages are sent to
keep the LDP session from timing out when no other LDP traffic is
being sent between the neighbors.
KA Timeout
The time interval, in seconds, that LDP waits before tearing down a
session. If no LDP messages are exchanged during this time interval,
the LDP session is torn down. Generally the value is configured to be 3
times the keepalive time (the time interval between successive LDP
keepalive messages).
Auth
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.
Passive Mode
The mode used to set up LDP sessions. This value is only applicable to
targeted sessions and not to LDP interfaces.
True — LDP responds only when it gets a connect request from a
peer and will not attempt to actively connect to its neighbors.
False — LDP actively tries to connect to its peers.
Auto Create
Specifies if a targeted peer was automatically created through service
manager. For an LDP interface, this value is always false.
No. of Peers
The total number of LDP peers.
Label Description (Continued)