Alcatel-Lucent 7210 SAS-X - Page 864

Show, Clear, Debug Commands
Page 864 7210 SAS-X OS Services Guide
Sample Output
*A:ALA-12# show service id 2 arp
==============================================================================
ARP Table
==============================================================================
IP Address MAC Address Type Age Interface Port
------------------------------------------------------------------------------
190.11.1.1 00:03:fa:00:08:22 Other 00:00:00 ies-100-190.11.1 1/1/11:0
==============================================================================
*A:ALA-12#
base
Syntax base
Context show>service>id
Description Displays basic information about the service ID including service type, description, SAPs and SDPs.
Output Show Service-ID Base — The following table describes show service-id base output fields:
Type
Static — FDB entries created by management.
Learned — Dynamic entries created by the learning process.
OAM — Entries created by the OAM process.
Age
The time elapsed since the service was enabled.
Interface
The interface applied to the service.
Port
The port where the SAP is applied.
Label Description
Service Id
The service identifier.
Vpn Id
Specifies the VPN ID assigned to the service.
Service Type
Specifies the type of service.
Description
Generic information about the service.
Customer Id
The customer identifier.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this customer.
Adm
The desired state of the service.
Oper
The operating state of the service.
Mtu
The largest frame size (in octets) that the service can handle.